Table of Contents
Repotting a Monstera Adansonii can help promote healthy growth and prevent root rot. Proper technique ensures you do not damage the plant’s delicate roots during the process. Follow these steps to repot your Monstera Adansonii safely and effectively.
Tools and Materials Needed
- New pot with drainage holes
- Well-draining potting mix
- Trowel or small shovel
- Gloves (optional)
- Watering can
- Scissors or pruning shears
Step-by-Step Repotting Process
1. Choose the Right Time
Repotting is best done during the active growing season, typically spring or early summer. This minimizes stress on the plant and encourages quick recovery.
2. Prepare the New Pot
Select a pot that is 1-2 inches larger in diameter than the current one. Ensure it has drainage holes to prevent waterlogging. Fill the bottom with a layer of well-draining potting mix.
3. Remove the Plant Carefully
Gently water the Monstera Adansonii a day before repotting to loosen the soil. Carefully slide a trowel or shovel around the edges of the pot to loosen the root ball. Support the plant with your hand and gently lift it out, avoiding pulling on the stems.
4. Inspect and Prune the Roots
Examine the roots for any signs of rot or damage. Use sterilized scissors or pruning shears to trim away dead or rotting roots. Be gentle to avoid damaging healthy roots.
5. Position the Plant in the New Pot
Place the Monstera Adansonii in the center of the new pot. Fill around the root ball with fresh potting mix, pressing lightly to eliminate air pockets. Keep the plant at the same depth as it was in the previous pot.
6. Water and Settle
Water the plant thoroughly until water drains from the bottom. This helps settle the soil and ensures good root contact. Place the plant in a location with bright, indirect light.
Post-Repotting Care
Allow the plant to adjust for a few days without fertilizing. Keep the soil moist but not waterlogged. Monitor for signs of stress or overwatering, and avoid repotting again until the plant shows healthy new growth.